Increased, vulcanised rubber protection at the sides and toe make these Moonstar All-Weathers more than worthy of their name.
FABRIC: Cotton canvas & rubber COLOUR: Beige DETAILS: -High top profile -Lace up design -Full canvas upper -Vulcanised rubber sole, sides, and toe box ORIGIN: Made in Japan
Moonstar have been honing their skills and championing made-in-Japan craft since 1873. The brand’s RF or “Refined” line ushers in the next step in their ongoing evolution with a series of amped-up design and construction details.The Moonstar All-Weather RF lace-up uses a tough cotton-nylon canvas and a vulcanised rubber sole to create a hardy, everyday sneaker. This high-top sneaker comes fitted with higher-set rubber sidings, toe cap, and vamp for an impermeable, waterproof finish. Each and every pair of Moonstars is hand cut, sewn, and assembled in Kurume, Japan, using the highest quality materials.
Button up the jean. Lay flat with the top waist band evenly flat on the back waist band. Measure from one side to the other keeping the jean flat & double the measurement.
Stage 2: The hip
Measure 3 inches or 7.5cm from the crotch stitch. Measure from side to side flat across the jean at this point.
Stage 3: Front rise
Lay flat and measure from crotch seam to top of jean with top button fastened
Stage 4: Back rise
Measure from crotch seam to top of the back of the jean.
Stage 5: Thigh
Lay flat and measure from crotch across to outside of leg.
Stage 6: Knee
Lay flat and measure 13” or 33cm from crotch down inside seam of jeans From here measure from one side of the jean to the other.
Stage 7: hem width/leg opening
With the jean flat measure from one side of the leg opening to the other. NB with very heavy denim 18oz and above measure the entire circumference of the exterior of the hem using a measuring tape and divide by 2 for a more exact figure.
Stage 8: Inseam/inside leg
Lay the jean flat with the inseam at the centre. Following the inside seam measure from the crotch to the end of the leg.
Stage 1: Chest
Measure from pit to pit and double the reading.
Stage 2: Shoulder
Measure across the top from one shoulder seam to the other.
Stage 3: Waist We measure the narrowest part of the garment outer seam to outer seam between the pit and the opening. If, however, the shirt has gussets, the waist will correspond to the the opening measurement.
Stage 4: Opening Here we take a cross measurement from seam to seam at the bottom of the shirt. Stage 5: Length Measure from the top of the shoulder by the collar to the bottom of the garment. Stage 6: Sleeve Measure from the top of shoulder seam to the cuff’s edge.
FREE European delivery on orders over €200.
Standard delivery is €30 for European orders under €200.
United States shop